Alcatel-Lucent OmniAccess 5740 - Interface Mlppp; Encapsulation Mlppp

Multilink Point to Point Protocol
Left running head:
Chapter name (automatic)
324
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
INTERFACE MLPPP
interface mlppp <1-256>
DESCRIPTION
This command is entered in the Configuration Mode. This command creates a
MLPPP bundle interface that is identified by the bundle ID.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# interface mlppp 100
ALU(config-if mlppp100)#
ENCAPSULATION MLPPP
encapsulation mlppp <1-256>
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command sets MLPPP encapsulation on an interface. The interface
becomes a member link of the bundle interface identified by the bundle ID.
PARAMETERS
DEFAULT VALUE
The default encapsulation on a serial interface is HDLC.
EXAMPLE
ALU(config)#interface Serial1/0:0
ALU(config-if Serial1/0:0)# encapsulation mlppp 100
Parameter Description
1-256 Bundle Identification. The range of the
bundle ID is between 1 and 256.
Parameter Description
1-256 Bundle Identification. The range of the
bundle ID is between 1 and 256.