Alcatel-Lucent OmniAccess 5740 - IKE Policy

speed
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
181
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
EXAMPLE 2
ALU# show interfaces GigabitEthernet 3/0
GigabitEthernet3/0 is up, line protocol is up
Hardware address is 0000.1111.2222 (0000.1111.2222)
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 0., loopback not set
Keepalive not set
Auto-duplex, Auto speed, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
5397 packets input, 380818 bytes, 0 no buffer
Received 21 broadcasts, 1 runts, 0 giants
2 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2465 multicast, 0 pause input
2503 packets output, 212146 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 2 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
ALU#
SPEED
speed {10|100|1000|auto}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
configures the interface speed.
PARAMETERS
None.
DEFAULT VALUE
The default speed is “auto”.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# speed 100