no fault-alarm reset-time
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
359
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NO FAULT-ALARM RESET-TIME
no fault-alarm reset-time [<250-1000>]
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to delete the configured fault alarm reset time and set it to
default value. The default reset-time is 1000 milliseconds.
FAULT-ALARM SET-TIME
no fault-alarm set-time [<250-1000>]
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to delete the interval timer settings configured for fault alarm
and reset it to default value. The default time interval is 250 milliseconds.
NO MACADDRESS
no macaddress [<mac-address>]
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to remove the MAC address configuration from a MEP. This
command sets the MAC address to the default, that is MEP takes the interface
MAC address as the default address.
NO MEP
no mep <1-8191> [direction {Down|Up} interface <name> [vlan <1-
4094>]]
This is entered in the OAM Domain Association Configuration Mode. This
command is used to disassociate the MEP from a MA.
NO PRIORITY
no priority [<0-7>]
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to delete the configured priority value and reset it to the default.
The default priority is 7.
NO REMOTE-MEP
no remote-mep <1-8191>
This is entered in the OAM Domain Association Configuration Mode. This
command is used to delete a remote MEP.
NO SHUTDOWN
no shutdown
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to administratively bring up the MEP.
To Next Page
Loading...
Need help?
General
