IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
808
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO LIFETIME
no lifetime {kilobytes|seconds}
This command is entered in the IPsec Profile Configuration Mode. The ‘no’
command resets the seconds lifetime to default. If set in kilobytes, the ‘no’
command removes the kilobytes lifetime value.
NO PFS
no pfs
This command is entered in the IPsec Profile Configuration Mode. The ‘no’
command disables PFS completely, when entered in the IPsec Profile
Configuration mode.
NO SHUTDOWN
no shutdown
This command is entered in the Interface Configuration Mode. This command is
used to administratively bring up the tunnel interface.
NO TRANSFORM-SET
no transform-set
This command is entered in the IPsec Profile Configuration Mode. The ‘no’
command detaches the specified transform-set attached to the profile, and
applies the 'default' transform set. A transform-set must be first detached from the
profile to delete it globally.
NO TUNNEL DESTINATION
no tunnel destination <ip-address>
This command is entered in the Interface Configuration Mode. The “no” command
removes the configured destination IP address configured for the tunnel.
NO TUNNEL SOURCE
no tunnel source {<ip-address>|<interface-name>}
This command is entered in the Interface Configuration Mode. The “no” command
removes the configured source IP address of the tunnel.
To Next Page
Loading...
Need help?
General
