Alcatel-Lucent OmniAccess 5740 - Network Attack Prevention Configuration Commands; All; Attack

Filter and Firewall
Left running head:
Chapter name (automatic)
706
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NETWORK ATTACK PREVENTION CONFIGURATION COMMANDS
ALL
all
DESCRIPTION
This command is entered in the Firewall-Attack Sub Configuration Mode. This
command is used to configure all the attacks (including all Default and Optional
attacks) for an attack object.
PARAMETERS
None.
EXAMPLE
ALU(config-firewall-attack-A1)# all
The following are the Optional attacks that are not present in the default
attack prevention list of the OmniAccess 5740 USG:
icmp_router_advertisement
icmp_redirect
ip_spoofing
icmp_block_trace_route
ip_source_routing
udp_snork_attack
ATTACK
attack <name>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure an attack object to be attached to a firewall policy.
PARAMETERS
EXAMPLE
ALU(config-firewall)# attack A1
ALU(config-firewall-attack-A1)#
Parameter Description
name Name of the attack.