Alcatel-Lucent OmniAccess 5740 - Dot1 X Timeout Quiet-Period; Dot1 X Timeout Reauth-Period

802.1X Port-Based Authentication
Left running head:
Chapter name (automatic)
220
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
DOT1X TIMEOUT QUIET-PERIOD
dot1x timeout quiet-period <1-3600>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the number of seconds that the OmniAccess 5740 USG remains in the quiet
state following a failed authentication exchange with the client.
PARAMETERS
DEFAULT VALUE
The default is 60 seconds.
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout quiet-period 50
DOT1X TIMEOUT REAUTH-PERIOD
dot1x timeout reauth-period <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the number of seconds between reauthentication attempts. This is valid only
if periodic reauthentication is enabled.
PARAMETERS
DEFAULT VALUE
The default is 3600 seconds.
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout reauth-period 4500
Parameter Description
1-3600
Indicates the number of seconds that the
OmniAccess 5740 USG remains in the
quiet state.
Parameter Description
1-65535
Indicates the number of seconds
between reauthentication attempts.