Alcatel-Lucent OmniAccess 5740 - Router Rip; Show Ip Protocols

Router Information Protocol
Left running head:
Chapter name (automatic)
480
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ROUTER RIP
router rip
DESCRIPTION
This command is entered in the Configuration Mode. This command enables the
RIP routing process.
PARAMETERS
None.
EXAMPLE
ALU(config)# router rip
ALU(config-router rip)#
SHOW IP PROTOCOLS
show ip protocols [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays a detailed routing configuration.
PARAMETERS
EXAMPLE
ALU# show ip protocols
Routing Protocol is "rip"
Sending updates every 30 seconds, next due in 27 seconds
Invalid after 180 seconds, hold down 180, flushed after 240 seconds
Default redistribution metric is 3
Redistributing External Routes from:
connected metric 3
static metric 4
Default version control: send version 2, receive version 2
Automatic network summarization is in effect
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Interface Send Recv Key-chain
GigabitEthernet3/1 2 2
loopback1 2 2
Routing for Networks:
1.0.0.0
4.0.0.0
Routing Information Sources:
Field Description
vrf-name Name of the VRF.