Alcatel-Lucent OmniAccess 5740 - Pppoe Service-Name

Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
320
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPPOE SERVICE-NAME
pppoe service-name <name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the PPPoE client to request a particular service (e.g. web-
access) supported by the PPPoE server.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# pppoe service-name ISP1
Note: Service name can be of maximum length 50 characters.
The PPPoE service-name configured on OmniAccess 5740 USG should match the
service-name supported on the server.
If “service-name” is not configured, then the client accepts any service offered by the
PPPoE server.
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
name Service name supported by the PPPoE
server.