area default-cost
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
551
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
AREA DEFAULT-COST
area {<0-4294967295>|<ip-address>} default-cost <0-16777215>
DESCRIPTION
This command is entered in the Router Configuration Mode. This command
specifies the cost for the default summary route sent into a stub or NSSA.
PARAMETERS
DEFAULT VALUE
Default cost is 1.
EXAMPLE
ALU(config-router ospf 30)# area 1 default-cost 100
Parameter Description
0-4294967295 OSPF area ID as a decimal value.
ip-address OSPF area ID in IP address format.
0-16777215 Cost for the default summary route used for a stub or NSSA.
The acceptable value is a 24-bit number.
To Next Page
Loading...
