Alcatel-Lucent OmniAccess 5740 - No Enable-Authentication; No Line Console Exec-Timeout; No Line Vty Exec-Timeout; No Logging Buffered

System Configuration and Monitoring
Left running head:
Chapter name (automatic)
76
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO ENABLE-AUTHENTICATION
no enable-authentication
This command is entered in the Configuration Mode. The ‘no’ command deletes
the existing enable-password configuration, thereby disabling enable-
authentication.
Note: As a result, console clients will be granted access to the enable-mode without being
prompted the password.
Remote clients will be denied access with the message 'No password Set'.
This is the default behavior.
NO LINE CONSOLE EXEC-TIMEOUT
no line console exec-timeout
This command is entered in the Configuration Mode. This command removes the
time-out configured for CLI session.
NO LINE VTY EXEC-TIMEOUT
no line vty exec-timeout
This command is entered in the Configuration Mode. This command removes the
time-out configured for SSH, Telnet, and Modem sessions.
NO LOGGING BUFFERED
no logging buffered
This command is entered in the Configuration Mode. This command disables the
log messages from getting stored into the memory buffer.
NO LOGGING CONSOLE
no logging console
This command is entered in the Configuration Mode. This command disables the
log messages from getting displayed on the console.
NO LOGGING ON
no logging on
This command is entered in the Configuration Mode. This command disables the
functionality of logging the messages.