Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

T1E1 Line Card
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
233
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CHAPTER 11 T1E1 LINE CARD
This chapter documents the CLI commands for the T1 and E1 controllers. These
commands can be used to access interface ports that are attached to the T1E1
controller. Some commands vary depending on whether you are configuring a T1
or an E1 controller. The document is hence divided into commands relating to E1
controller and T1 controller separately (“E1 CLI Commands” and “T1 CLI
Commands”).
It includes table of parameters, default values, and configuration examples for
both the E1 and T1 controller configuration as a quick-start and reference
information. Within each of these sections, the commands are described in
alphabetical order. For more detailed information about using and configuring the
T1 or E1 CLI, refer to the OmniAccess 5740 Unified Services Gateway CLI
Configuration Guide.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English