Bridging Configuration
Left running head:
Chapter name (automatic)
378
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW INTERFACES MLPPP
show interfaces mlppp <1-256>
DESCRIPTION
This is entered in the Super User Mode or Configuration Mode or Interface
Configuration Mode. This command displays bridging statistics on the MLPPP
interface.
PARAMETERS
EXAMPLE
ALU(config)# show interfaces mlppp 1
mlppp1 is up, line protocol is up
Internet address not set
MTU 1494 bytes, BW 1984 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation mlppp, loopback not set
BCP: Open
IPCP: Stopped
Last input never, output never, output hang never
Last clearing of "show interface" counters never
5 minutes input rate 160 bits/sec, 0 packets/sec
5 minutes output rate 160 bits/sec, 0 packets/sec
16 packets input (2 Control packets, 14 Data packets), 1198 bytes
8 packets output (2 Control packets, 6 Data packets), 678 bytes
0 Small packets dropped, 0 giants received
0 protocol packets dropped, 0 non ppp packets dropped
14 packets bridged, 2 bridge packets dropped
Fragmentation: Fragment Delay 0 ms
0 fragmented, 0 couldn't fragment
0 fragments created, 0x18 sent sequence
Reassembly: Slippage MRU 32
0 fragments in reassembly list
0 lost fragments, 0 reordered
0 discarded fragments, 0 reassembled
0 lost received, 0 couldn't reassemble
0 fragments received, 0x16 received sequence
Parameter Description
1-256 MLPPP bundle identification. The range
of the bundle ID is between 1 and 256.
To Next Page
Loading...
