Alcatel-Lucent OmniAccess 5740 - Ip Ospf Cost; Ip Ospf Database-Filter All out

ip ospf cost
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
563
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
IP OSPF COST
ip ospf cost <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
explicitly specifies the cost of sending a packet on an OSPF interface.
Note: The value set by the ‘ip ospf cost’ command overrides the cost resulting from the auto-
cost command.
PARAMETERS
DEFAULT VALUE
The default cost is calculated based on the interface bandwidth.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf cost 100
IP OSPF DATABASE-FILTER ALL OUT
ip ospf database-filter all out
DESCRIPTION
This command is entered in the Interface Configuration Mode. Enables filtering of
outgoing LSAs on OSPF interface.
PARAMETERS
None.
DEFAULT VALUE
By default, database-filtering is not enabled. All outgoing LSAs are flooded to the
interface.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf database-filter all
out
Parameter Description
1-65535 Unsigned integer value expressed as the link-state metric.