IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
806
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IPSEC-PROFILE
ipsec-profile <profile-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to attach the configured IPsec profile to the tunnel interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if Tunnel1)# ipsec-profile PF1
LIFETIME
lifetime {kilobytes <512-2147483647>|seconds <540-86400>}
DESCRIPTION
This command is entered in the IPsec Profile Configuration Mode. This command
configures lifetime for an IPsec profile. Use Kilobytes keyword to configure lifetime
in kilobytes, and use Seconds keyword to configure lifetime in seconds for a
profile.
PARAMETERS
DEFAULT VALUE
Lifetime has a default value of 28800 seconds. There is no default value for
lifetime in Kilobytes.
EXAMPLE
ALU(ipsec-profile-PF1)# lifetime seconds 1000
ALU(ipsec-profile-PF1)# lifetime kilobytes 1005236
Parameter Description
profile-name Name of the IPsec profile.
Parameter Description
512-2147483647 Specify the time in kilobytes.
540-86400 Specify the time in seconds.
To Next Page
Loading...
Need help?
General
