Alcatel-Lucent OmniAccess 5740 - Show Interface

Multilink Frame Relay
Left running head:
Chapter name (automatic)
336
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW INTERFACE
show interfaces mlfr [<1-256>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the configuration of the MLFR bundle interface specified.
PARAMETERS
EXAMPLE
ALU(config)# show interfaces mlfr 1
mlfr1 is up, line protocol is up
Internet address is 192.168.1.1/24
Bundle id is mlfr1, keepalive set (10 sec)
LMI enq sent 26219, LMI stat recvd 325, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is CCITT(q933a) frame relay DTE
MTU 1500 bytes, BW 3072 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation mlfr-bundle, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
614 packets input( 325 controld packets, 289 data packets),34295 bytes
26599 packets output( 26216 controld packets, 383 data packets),458430 bytes
53 packets dropped 0 giant packets
Parameter Description
1-256 Number that identifies the MLFR bundle.