EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Alcatel-Lucent OmniAccess 5740
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #269 background imageLoading...
Page #269 background image
T1E1 Line Card
Left running head:
Chapter name (automatic)
234
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
E1 CLI COMMANDS
This section deals with the commands relevant to only the E1 controller.
CARD TYPE
card type {E1|T1} <slot>
DESCRIPTION
This command is entered in the Configuration Mode to set the card type of E1
controller in a specific slot.
PARAMETERS
DEFAULT VALUE
By default, no card type is installed.
EXAMPLE
The following example sets the card type of E1 controller:
OA(config)# card type E1 0
Note: The line card is not functional until card type is set. Reboot/Reload the chassis to
change the card type, which will remove the previous configuration. Use controller
and channel-group commands to relaod the card type.
Parameter Description
E1|T1 Sets the card type to E1 or T1.
Use E1 keyword to set the card type
to E1.
slot Enter the specified slot number.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals