Alcatel-Lucent OmniAccess 5740 - L2 Filter {In|Out

Filter and Firewall
Left running head:
Chapter name (automatic)
698
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
L2 FILTER {IN|OUT}
l2 filter {in|out} <filter-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to attach a L2 filter to an interface in ‘in’ or ‘out’ direction.
Note: Each interface can have one ingress and one egress L2 filter.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# interface GigabitEthernet 3/0
ALU(config-if GigabitEthernet3/0)# l2 filter in F1
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
in|out Filter is applied to the ingress (incoming)
traffic if “in” keyword is used.
Filter is applied to the egress (outgoing)
traffic if “out” keyword is used.
filter-name Name for the L2 filter.