Alcatel-Lucent OmniAccess 5740 - Frame-Relay Qos-Bandwidth Percent

Quality of Service
Left running head:
Chapter name (automatic)
890
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
FRAME-RELAY QOS-BANDWIDTH PERCENT
frame-relay qos-bandwidth percent <1-100>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure bandwidth on an interface (PVC). This configuration overrides
the default bandwidth sharing.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if Serial0/0:0)# frame-relay qos-bandwidth percent
30
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
1-100 The bandwidth in percentage.