Multilink Frame Relay
Left running head:
Chapter name (automatic)
330
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ENCAPSULATION MLFR
encapsulation mlfr <1-256>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the encapsulation on an interface to MLFR, and attaches it to the bundle
interface configured.
PARAMETERS
DEFAULT VALUE
The default encapsulation on a serial interface is HDLC.
EXAMPLE
ALU(config)#interface Serial1/0:0
ALU(config-if Serial1/0:0)# encapsulation mlfr 100
FRAME RELAY INTERFACE DLCI
frame-relay interface-dlci <16-1007>
DESCRIPTION
This command is entered in Interface Configuration Mode. This command is used
to configure a DLCI on a MLFR interface.
PARAMETERS
EXAMPLE
ALU(config-if mlfr100)# frame-relay interface-dlci 100
Parameter Description
1-256 Bundle identification. This number can
vary from 1 - 256.
Parameter Description
16-1007 The DLCI value.