Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

High-level Data Link Control
Left running head:
Chapter name (automatic)
272
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ENCAPSULATION HDLC
encapsulation hdlc
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure encapsulation on an interface to HDLC.
PARAMETERS
None.
DEFAULT VALUE
HDLC is the default encapsulation on T1E1 or a serial interface.
EXAMPLE
ALU(config-if Serial0/0:0)# encapsulation hdlc
HDLC KEEPALIVE
hdlc keepalive <0-32767>
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command configures the HDLC keepalive interval. The same value shall be
configured on the peer. A value of ‘0’ turns off the keepalive feature.
PARAMETERS
DEFAULT VALUE
Default is 10 seconds.
EXAMPLE
ALU(config-if Serial0/0:0)# hdlc keepalive 12
Parameter Description
0-32767 HDLC keepalive interval in the range of 0
- 32767 seconds.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English