range
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
949
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
RANGE
range {<lower ip-address> <higher ip-address>|<automatic>}
DESCRIPTION
This command is entered in the DHCP Pool Configuration Mode.
This command is used to configure the range of IP addresses within the network
of the pool, which are used to service DHCP requests from the clients.
Specification of range is mandatory for a network pool. The range cannot include
the network address and the broadcast address of the network.
Note: The network configuration for a pool must exist before a range can be specified.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-dhcp-pool-p1)# range 1.2.3.50 1.2.3.100
ALU(config-dhcp-pool-p1)# range automatic
Parameter Description
<lower ip-address> <higher ip-
address>
Lower and the upper addresses of the
network range.
automatic Specify entire network addresses to be
available to the client.
To Next Page
Loading...
Need help?
General
