Multilink Point to Point Protocol
Left running head:
Chapter name (automatic)
326
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW INTERFACES MLPPP
show interfaces mlppp <1-256>
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the configuration of the MLPPP bundle interface specified.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)#show interfaces mlppp 10
mlppp10 is up, line protocol is up
Internet address is 1.11.1.1/24
MTU 1494 bytes, BW 128 Kbit, DLY 0 usec,
reliability 255/255, txload 237/255, rxload 0/255
Encapsulation mlppp, loopback not set
IPCP: Initial
Last input never, output never, output hang never
Last clearing of "show interface" counters never
0 packets input (0 Control packets, 0 Data packets), 0 bytes
0 packets output (0 Control packets, 0 Data packets), 0 bytes
0 packets dropped, 0 giants received
Fragmentation: Fragment Delay 0 ms
0 fragmented, 0 couldn't fragment
0 fragments created, 0x0 sent sequence
Reassembly: Slippage MRU 32
0 fragments in reassembly list
0 lost fragments, 0 reordered
0 discarded fragments, 0 reassembled
0 lost received, 0 couldn't reassemble
0 fragments received, 0x0 received sequence
RELEASE HISTORY
Release 2.3: fragmentation parameters was introduced.
Parameter Description
1-256 Bundle Identification. This varies from 1-
256.