Alcatel-Lucent OmniAccess 5740 - Firewall and Security; Filters

Point to Point Protocol
Left running head:
Chapter name (automatic)
294
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPP AUTHENTICATION CLIENT-PASSWORD
ppp authentication client-password <password>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
enables you to set the password for PPP authentication on the client side.
PARAMETERS
EXAMPLE
ALU(config-if Serial0/0:0)# ppp authentication client-password
pass1
PPP AUTHENTICATION CLIENT-USERNAME
This command is entered in the Interface Configuration Mode. ppp
authentication client-username <user-name>
DESCRIPTION
This command is used to set user name for PPP authentication on the client side.
PARAMETERS
EXAMPLE
ALU(config-if Serial0/0:0)# ppp authentication client-username
client1
Parameter Description
password Denotes the password for PPP authentication.
Parameter Description
user-name Denotes the user name for PPP authentication.