Router Information Protocol
Left running head:
Chapter name (automatic)
470
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP RIP TRIGGERED
ip rip triggered
DESCRIPTION
Note: This is valid only for Serial interfaces only.
This command is entered in the Interface Configuration Mode. This command is
used to provide support for RIP trigger update [RFC-2091: Triggered Extensions
to RIP to Support Demand Circuits].
PARAMETERS
None.
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if Serial0/0:1)# ip rip triggered
RELEASE HISTORY
Release 2.3.2: command was introduced.
To Next Page
Loading...
