T1E1 Line Card
Left running head:
Chapter name (automatic)
258
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW CONTROLLER
show controller [{E1|T1} <port>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays controller status that is specific to the controller hardware. The
show controllers T1 command displays the status of T1 controllers and displays
information about clocksources and other settings for the ports.
PARAMETERS
None.
EXAMPLE
ALU# show controller
T1 1/0 is administratively down.
T1 1/1 is administratively down.
T1 1/2 is up.
Line Card type is Channelized T1
Cablelength is long 0db
No Alarm Detected
Framing is esf, Line Code is b8zs, Clock Source is internal
Total Data (Since last clearing of counters)
0 Line Code Violation, 0 Framing Errors
0 Out of Frame, 0 Bit Errors
T1 1/3 is administratively down.
ALU# show controller T1 1/2
T1 1/2 is up.
Line Card type is Channelized T1
Cablelength is long 0db
No Alarm Detected
Framing is esf, Line Code is b8zs, Clock Source is internal
Total Data (Since last clearing of counters)
0 Line Code Violation, 0 Framing Errors
0 Out of Frame, 0 Bit Errors
To Next Page
Loading...
