Port Monitoring
Left running head:
Chapter name (automatic)
228
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO PORT MONITOR INTERFACE SWITCHPORT
no port monitor interface switchport <slot/port>
[{both|egress|ingress}]
This command is entered in the Interface Configuration Mode. This command is
used to disable port monitoring. Specify the slot/port on which traffic is not to be
monitored.
PORT MONITOR INTERFACE SWITCHPORT
port monitor interface switchport <slot/port>
[{both|egress|ingress}]
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure port monitoring. Specify the traffic to be monitored.
PARAMETERS
DEFAULT VALUE
By default, the both (egress and ingress) traffic is monitored.
EXAMPLE
The following example shows that the switchports 1/6 and 1/7 are to be
monitored. Switchport 1/0 being the destination port, i.e, port receives the
mirrored data from switchports 1/6 and 1/7.
ALU(config-if switchport1/0)# port monitor switchport 1/6
both
ALU(config-if switchport1/0)# port monitor switchport 1/7
ingress
Parameter Description
both Monitor both ingress and egress traffic.
egress Monitor egress traffic.
ingress Monitor ingress traffic.
To Next Page
Loading...
Need help?
General
