area virtual-link
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
555
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
AREA VIRTUAL-LINK
area {<0-4294967295>|<ip-address>} virtual-link <router-id>
[authentication [message-digest|null] [[hello-
interval|retransmit-interval retransmit-interval|transmit-
delay|dead-interval] <1-8192>] authentication-key <0-0> <key>]|
message-digest-key <1-255> md5 <key>]]
DESCRIPTION
This command is entered in the Router Configuration Mode. This command
establishes a virtual link with neighbor specified by router ID.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-router ospf 30)# area 1 virtual-link 202.202.202.5
Parameter Description
0-4294967295 Identifier for the OSPF stub area as a decimal value.
ip-address Identifier for the OSPF stub area as an IP address.
router-id Router ID associated with virtual link neighbor. The router
ID appears in the ‘show ip ospf’ display. The router ID is
internally derived by each router from the interface IP
addresses. This value must be entered in the same format
as an IP address. There is no default.
authentication
[message-
digest|null]
Enable authentication over virtual link.
1-8192 The dead interval.
authentication-
key <0-0> key
The authentication key.
<1-255> md5 key The message digest authentication key identifier.
To Next Page
Loading...
Need help?
General
