Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

client-ip-list
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
827
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CLIENT-IP-LIST
Client-IP-list <list-name>
DESCRIPTION
This command is entered in the Client Object Configuration Mode. This command
is used to attach a pre-configured list that contains a list of IP addresses to be
assigned to the IPsec clients.
Note: The list should have contain host or only prefix or a combination of both.
For more information on configuring list and its rule, refer to the “Common Classifiers”
chapter in this guide.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
The following example shows a list with only host attached a crypto client object.
ALU(config)# list L1 host 192.168.1.0
ALU(config)# end
ALU(config)# crypto client object myclientobject
ALU(config-client-obj-myclientobject)# Client-IP-list L1
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
list-name Name of the list that has a list of
addresses to be assigned to IPsec
clients.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English