Open Shortest Path First
Left running head:
Chapter name (automatic)
572
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO LOG-ADJACENCY-CHANGES
no log-adjacency-changes
This command is entered in the Router Configuration Mode. This command is
used to disable logging.
NO AREA AUTHENTICATION
no area {<0-4294967295>|<ip-address>} authentication [message-
digest]
This command is entered in the Router Configuration Mode. The “no” command
disables authentication for an OSPF area.
NO AREA DEFAULT-COST
no area {<0-4294967295>|<ip-address>} default-cost <0-16777215>
This command is entered in the Router Configuration Mode. The “no” command
removes the specific cost assigned to the default summary route used for the stub
area/NSSA.
NO AREA NSSA
no area {<0-4294967295>|<ip-address>} nssa [default-
information-originate] [no-summary] [no-redistribution]
This command is entered in the Router Configuration Mode. The “no” command
sets area to default.
NO AREA RANGE
no area {<0-4294967295>|<ip-address>} range {<ip-address
subnet-mask|<ip-address/prefix-length>}[not-advertise]
This command is entered in the Router Configuration Mode. The “no” command
removes the address range for which a single route is to be advertised.
NO AREA STUB
no area {<0-4294967295>|<ip-address>} stub [no-summary]
This command is entered in the Router Configuration Mode. The “no” command
sets area to default.
NO AREA VIRTUAL-LINK
no area {<0-4294967295>|<ip-address>} virtual-link <router-id>
[authentication [message-digest|null] [[hello-
interval|retransmit-interval retransmit-interval|transmit-
delay|dead-interval] <1-8192>] authentication-key <0-0> <key>]|
message-digest-key <1-255> md5 <key>]]
This command is entered in the Router Configuration Mode. The “no” command
removes the virtual link with neighbor specified by router ID.
To Next Page
Loading...
