Alcatel-Lucent OmniAccess 5740 - Ip Pim Neighbor-Filter; Ip Pim Rp-Address

Multicast Routing
Left running head:
Chapter name (automatic)
610
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP PIM NEIGHBOR-FILTER
ip pim neighbor-filter {<1-99>|<standard access-list-name>}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to prevent PIM router from forming neighborship with other router. Using
access-list, you can specify permitted neighbors.
PARAMETERS
DEFAULT VALUE
By default, PIM router forms neighborship with all the routers on an interface.
EXAMPLE
ALU(config-if Serial0/0:0)# ip pim neighbor-filter acc-list1
IP PIM RP-ADDRESS
ip pim rp-address <ip-address> [override]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the RP router address for all multicast groups.
Note: All routers in the PIM domain should have same RP address for a multicast group.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# ip pim rp-address 11.0.0.3
Parameter Description
1-99 Standard access-list number.
standard access-
list-name
Name of a specific access list. Use this to specify
permitted neighbors.
Parameter Description
ip-address RP router address.
override This is used to give preference to static RP over dynamic RP.