Alcatel-Lucent OmniAccess 5740 - Show Interfaces Mlppp

show interfaces mlppp
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
389
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW INTERFACES MLPPP
show interfaces mlppp <1-256>
DESCRIPTION
This command is entered in the Super User Mode, Configuration Mode or
Interface Configuration Mode. This command displays the LFI configuration on
the MLPPP bundle interface specified.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# show interface mlppp 100
mlppp100 is up, line protocol is up
Internet address is 20.20.20.20/24
MTU 1494 bytes, BW 512 Kbit, DLY 0 usec,
reliability 255/255, txload 10/255, rxload 10/255
Encapsulation mlppp, loopback not set
IPCP: Open
Last input never, output never, output hang never
Last clearing of "show interface" counters never
2 packets input (2 Control packets, 0 Data packets), 28 bytes
2 packets output (2 Control packets, 0 Data packets), 28 bytes
0 packets dropped, 0 giants received
Fragmentation: Fragment Delay 10 ms
5 fragmented, 0 couldn't fragment
10 fragments created, 0x9 sent sequence
Reassembly: Slippage MRU 16
0 fragments in reassembly list
0 lost fragments, 0 reordered
11 discarded fragments, 0 reassembled
0 timeouts, 0 couldn't reassemble
0 fragments received, 0xb received sequence
RELEASE HISTORY
Release 2.3: command was modified.
Parameter Description
1-256 Bundle Identification. This varies from 1-
256.