Alcatel-Lucent OmniAccess 5740 - Ip Pim Sparse-Mode; No Ip Pim Sparse-Mode

Multicast Routing
Left running head:
Chapter name (automatic)
624
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP PIM SPARSE-MODE
ip pim sparse-mode
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to enable IGMP on an interface. After enabling this
command, IGMP learns the multicast host information on given interface.
PARAMETERS
None.
DEFAULT VALUE
By default IGMP is not enabled on an interface.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
NO IP PIM SPARSE-MODE
no ip pim sparse-mode
This command is entered in the Interface Configuration Mode. This command is
used to disable IGMP on an interface.