Alcatel-Lucent OmniAccess 5740 - Show Ip Mroute

Multicast Routing
Left running head:
Chapter name (automatic)
628
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW IP MROUTE
show ip mroute [<group-address>] [<interface-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the multicast routing table.
PARAMETERS
EXAMPLE
ALU# show ip mroute
IP Multicast Forwarding Information Base
Flags: T - SPT-bit set
(*, 224.1.1.1), uptime 0:10:21, flags:
Rates: Waiting for latest...
Incoming Interface: GigabitEthernet3/1, RPF failures 0
Outgoing Interfaces (1):
GigabitEthernet3/0
(4.4.4.4, 224.1.1.1), uptime 0:30:20, expired, flags:
Rates: Waiting for latest...
Incoming Interface: Serial0/0:0, RPF failures 0
Outgoing Interfaces (1):
GigabitEthernet3/0
(*, 225.5.5.5), uptime 0:09:37, flags:
Rates: Waiting for latest...
Incoming Interface: GigabitEthernet3/1, RPF failures 0
Outgoing Interfaces (0):
Parameter Description
group-address Displays the routing table entry for the given multicast group
address.
interface-name Displays the multicast routes for which specified interface is
outgoing interface.