Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
316
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPPOE AC-NAME
pppoe ac-name <access-concentrator-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the access concentrator name of the PPPoE server.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe ac-name ISP123
Note: The access concentrator name configured on OmniAccess 5740 USG should match
the concentrator name of the server.
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
access-concentrator-name Access concentrator name of the PPPoE
server.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English