Alcatel-Lucent OmniAccess 5740 - Show Ip Ospf

show ip ospf
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
575
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW IP OSPF
show ip ospf [<1-65535>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays general information about the OSPF routing processes.
PARAMETERS
EXAMPLE
ALU# show ip ospf
Routing Process "ospf 1" with ID 1.1.1.2
Supports only single TOS(TOS0) routes
Supports opaque LSA
It is an area border and autonomous system boundary router
Redistributing External Routes from:
connected route-map permit
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Minimum LSA interval 5 secs. Minimum LSA arrival 1 secs
Number of external LSA 4. Checksum Sum 0x1c8fd
Number of opaque AS LSA 0. Checksum Sum 0x0
Number of areas in this router is 2. 2 normal 0 stub 0 nssa
Full neighbors 2
External flood list length 0
Area BACKBONE(0)
Number of interfaces in this area is 1
Area has message digest authentication
SPF algorithm executed 36 times
Area ranges are
Number of LSA 6. Checksum Sum 0x35E53
Number of opaque link LSA 0. Checksum Sum 0x0
Flood list length 0
Area 1
Number of interfaces in this area is 1
Area has no authentication
SPF algorithm executed 8 times
Area ranges are
Number of LSA 5. Checksum Sum 0x234A3
Number of opaque link LSA 0. Checksum Sum 0x0
Flood list length 0
ALU#
Parameter Description
1-65535 Process ID. If this argument is included, only information for
the specified routing process is displayed.