Multicast Routing
Left running head:
Chapter name (automatic)
622
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP IGMP LAST-MEMBER-QUERY-INTERVAL
ip igmp last-member-query-interval <100-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. Use this command
to configure the last-member query interval (in milliseconds) for the IGMP.
PARAMETERS
DEFAULT VALUE
The default last-member-query-interval is 1000 milliseconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp last-member-query-
interval 2000
IP IGMP QUERY-INTERVAL
ip igmp query-interval <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the interval (in seconds) at which the IGMP router sends query
messages on an interface.
PARAMETERS
DEFAULT VALUE
The default query-interval is 125 seconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp query-interval
100
Parameter Description
100-65535 Denotes the time the router waits for the membership report
after sending membership query.
Parameter Description
1-65535 Denotes the interval at which the IGMP router sends IGMP
general query messages.
To Next Page
Loading...
Need help?
General
