Alcatel-Lucent OmniAccess 5740 - Ppp Lcp Echo-Interval; Ppp Lcp Negotiate

Point to Point Protocol
Left running head:
Chapter name (automatic)
298
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPP LCP ECHO-INTERVAL
ppp lcp echo-interval <0-255>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to set the interval between the LCP echo requests sent. “0” implies that no
echo requests are sent.
PARAMETERS
DEFAULT VALUE
The default value is 10 seconds.
EXAMPLE
ALU(config-if Serial1/0:0)# ppp lcp echo-interval 200
PPP LCP NEGOTIATE
ppp lcp negotiate
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to initiate the LCP negotiation on the interface.
Note: LCP negotiation is automatically started when the encapsulation is set to PPP or when
the link is administratively brought up on a PPP interface, or when the MTU is
changed on the interface.
PARAMETERS
None.
EXAMPLE
ALU(config-if Serial1/0:0)# ppp lcp negotiate
Parameter Description
0-255 Denotes the interval between echo requests.