Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

tunnel destination
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
811
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
TUNNEL DESTINATION
tunnel destination <ip-address>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the destination IP address of the tunnel at the remote end.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if Tunnel1)# tunnel destination 2.2.2.3
TUNNEL SOURCE
tunnel source {<ip-address>|<interface-name>}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the source IP address of the tunnel.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if Tunnel1)# tunnel source 2.2.2.1
or
ALU(config-if Tunnel1)# tunnel source GigabitEthernet3/0
Parameter Description
ip-address Destination IP address of the tunnel.
Parameter Description
ip-address Source IP address of the tunnel.
interface-name Name of the interface

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English