Alcatel-Lucent OmniAccess 5740 - Debug Firewall Nat; Ip Nat

Network Address Translation
Left running head:
Chapter name (automatic)
682
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
DEBUG FIREWALL NAT
debug firewall {session|filter|nat|attack|alg|intrusion
|selector [saddr <ip-address>|daddr <ip-address>|protocol
<number>|sport <number> | dport <number>][output|permanent]|all
[detail-level]}
DESCRIPTION
This command is entered in the NAT Configuration Mode. This command turns on
the debugging functionality for NAT on the OmniAccess 5740 USG.
PARAMETERS
EXAMPLE
ALU# debug firewall nat
IP NAT
ip nat <nat policy-name>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure a NAT policy. This command enters the NAT Configuration Mode.
PARAMETERS
EXAMPLE
ALU(config)# ip nat N1
ALU(config-nat-N1)#
Parameter Description
saddr <ip-address> Source address.
daddr <ip-address> Destination address.
protocol <number> Protocol.
sport <number> Source port number.
dport <number> Destination port number.
output Specify output.
permanent Allow debug flag(s) to be written with
configuration.
Parameter Description
nat policy-name Name of the NAT policy.