Alcatel-Lucent OmniAccess 5740 - Spanning-Tree Vlan Port-Priority

Per VLAN Spanning Tree +
Left running head:
Chapter name (automatic)
208
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SPANNING-TREE VLAN PORT-PRIORITY
spanning-tree [vlan <1-4094>] port-priority <0-255>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to prioritize an interface.
Note: - When two bridges compete for position as the root bridge, port-priority command is
used to prioritize an interface.
- PVST+ Port Priority is configured on a per port basis.
PARAMETERS
DEFAULT VALUE
The default value for port-priority is: 128
EXAMPLE
ALU(config-if switchport1/0)# spanning-tree vlan 100 port-
priority 250
Parameter Description
0-255 PVST+ port-priority.