Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Link Fragmentation and Interleaving (LFI)
Left running head:
Chapter name (automatic)
386
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
LFI CONFIGURATION ON MLPPP CLI COMMANDS
This section deals with the commands relevant to LFI configuration on MLPPP
interface.
FRAGMENT DELAY
fragment delay <1-256>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is used
to configure the fragment delay on the MLPPP bundle interface.
PARAMETERS
DEFAULT VALUE
The default value of fragment delay is 0, i,e., no fragmentation will be performed.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# interface mlppp 100
ALU(config-if mlppp100)# fragment delay 10
Note: The MTU (Maximum Transmission Unit) of the individual links in a MLPPP bundle
should be greater than the fragment size.
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
1-256 Fragment delay range (in milli seconds).
Fragment delay on the MLPPP interface
specifies how long it will take for a
fragment to exit the interface.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English