no debug firewall
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
723
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NO DEBUG FIREWALL
no debug firewall {session|filter|nat|attack|alg|intrusion|
selector [saddr <ip-address>|daddr <ip-address>|protocol
<number>|sport <number>|dport <number>][output|permanent]|all
[detail-level]}
This command is entered in the Super User Mode or Configuration Mode. This
command turns off the debugging functionality which is enabled using the above
command. The “selector” keyword allows you to turn off debugging only for
selected traffic.
NO DEFAULT
no default [stateless]
This command is entered in the Firewall-Attack Sub Configuration Mode. The ‘no’
command disables all the default attacks configured for an attack object. Stateless
keyword disables only the stateless default attacks.
NO FIREWALL POLICY {IN|OUT}
no firewall policy {in|out} <policy-name>
This command is entered in the Interface Configuration Mode. This command
detaches a firewall policy attached to an interface. This command does not delete
the firewall policy definition in its entirety. It only detaches it from its interface. If
the command "no firewall policy name" is issued at the top level and if this
firewall policy is not bound to any interface, it deletes the firewall policy definition.