Alcatel-Lucent OmniAccess 5740 - Frame-Relay Lmi-N393 Dte; No Debug Frame-Relay; No Encapsulation Frame-Relay; No Frame-Relay Interface-Dlci

Frame Relay
Left running head:
Chapter name (automatic)
282
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
FRAME-RELAY LMI-N393DTE
frame-relay lmi-n393dte <1-10>
DESCRIPTION
This command is entered in the Interface Configuration Mode. It sets the DTE
monitored events count.
PARAMETERS
DEFAULT VALUE
The default value is 4.
EXAMPLE
The following example sets the DTE monitored events count to 7.
ALU(config-if serial0/0:0)# frame-relay lmi-n393dte 7
NO DEBUG FRAME-RELAY
no debug frame-relay {all|fse|keepalive|mlfr}
This command is entered in the Super User Mode or Configuration Mode. The
“no” command disables the debug functionality. By default, debug is disabled.
NO ENCAPSULATION FRAME-RELAY
no encapsulation frame-relay
This command is entered in the Interface Configuration Mode. The “no” command
resets the encapsulation on an interface to its default. The default encapsulation is
HDLC.
NO FRAME-RELAY INTERFACE-DLCI
no frame-relay interface-dlci <16-1007>
This command is entered in the Interface Configuration Mode or Sub Interface
Configuration Mode. The “no” command deletes the configured DLCI from the
interface.
Parameter Description
1-10 The range for DTE monitor event count.