network area
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
571
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NETWORK AREA
network {<ip-address subnet-mask>|<ip-address/prefix-length>}
area {<0-4294967295>|<ip-address>}
DESCRIPTION
This command is entered in the Router Configuration Mode. Enables routing on
an IP network and the area ID for that interface.
Note: Area ‘0’ is called the backbone area.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-router ospf 30)# network 10.0.0.0/8 area 1
NO PASSIVE-INTERFACE
no passive-interface {<interface-name>|default}}
This command is entered in the Router Configuration Mode. The “no” command
enables sending of hello packets and routing updates on a specified interface.
Parameter Description
<ip-address
subnet-mask|<ip-
address/prefix-
length>
IP address with subnet mask or prefix length.
area <0-
4294967295>
Area ID that is to be associated with the OSPF address
range. It can be specified as either a decimal value or as an
IP address. If you intend to associate areas with IP subnets,
you can specify a subnet address as the value of the area-id
argument.
area <ip-
address>
OSPF area ID in IP address format.
To Next Page
Loading...
