version
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
489
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
VERSION
version {1 | 2}
DESCRIPTION
This command is entered in the Router Configuration Mode. This command is
used to configure RIP version - v1/v2 on the OmniAccess 5740 USG.
Note: RIPv2 is an enhancement of RIPv1 and not a separate protocol.
By default, the RIP process configured on the OmniAccess 5740 USG sends only
RIPv1 messages but receives both RIPv1 and RIPv2 messages.
PARAMETERS
DEFAULT VALUE
By default, the software receives both RIP Version 1 and Version 2 packets, but
sends only Version 1 packets. You can configure the software to do the following:
• Receive and send only Version 1 packets.
• Receive and send only Version 2 packets.
• Receive and send Version 1 and 2 packets.
EXAMPLE
ALU(config-router rip)# version 1
Parameter Description
1 Specifies RIP Version 1. Send and receive only RIPv1
messages.
2 Specifies RIP Version 2. Send and receive only RIPv2
messages.
To Next Page
Loading...
Need help?
General
