Alcatel-Lucent OmniAccess 5740 - Interface; No Vrrp Group-ID; No Vrrp Group-ID IP; No Vrrp Group-ID Ip Ip-Address Secondary

interface
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
157
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
INTERFACE
interface <name>
DESCRIPTION
This command is used in the Configuration Mode. VRRP is enabled on a per-
interface basis. VRRP runs on multi-access networks, such as Ethernet. This
command is used to configure an interface.
PARAMETERS
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
NO VRRP GROUP-ID
no vrrp <1-8>
This command is entered in the Interface Configuration Mode. This command
removes the primary IP address for the specified VRRP group on an interface.
VRRP group is disabled as a result.
NO VRRP GROUP-ID IP
no vrrp <1-8> ip <ip-address>
This command is entered in the Interface Configuration Mode. This command
removes the primary IP address for the specified VRRP group on an interface.
VRRP group is disabled as a result.
NO VRRP GROUP-ID IP IP-ADDRESS SECONDARY
no vrrp <1-8> ip <ip-address> secondary
This command is entered in the Interface Configuration Mode. This command
removes only the secondary IP address from the specified VRRP group.
NO VRRP GROUP-ID PREEMPT
no vrrp <1-8> preempt
This command is entered in the Interface Configuration Mode. This command is
used to disable pre-emption of the VRRP group.
Parameter Description
name Type of interface used (Gigabit Ethernet).