Switching on L2 Ports
Left running head:
Chapter name (automatic)
186
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
INTERFACE SWITCHPORT
interface switchport <slot/port>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure an L2 interface.
PARAMETERS
EXAMPLE
ALU(config)# interface switchport 1/0
ALU(config-if switchport1/0)#
NO DUPLEX
no duplex
This command is entered in the Interface Configuration Mode. This command
restores the default duplex operation. The default duplex mode is “auto”.
NO SHUTDOWN
no shutdown
This command is entered in the Interface Configuration Mode. This command is
used to administratively bring up the interface.
NO SPEED
no speed
This command is entered in the Interface Configuration Mode. This command is
entered in the Interface Configuration mode. This command resets the interface
speed to its default value, which is “auto”.
NO SWITCHPORT ACCESS VLAN
no switchport access vlan
This command is entered in the Interface Configuration Mode. This command
deletes the access VLAN-ID configured on the port. This makes it to switch over
to the pure bridging mode.
Parameter Description
slot/port The slot and port numbers of the
interface.
To Next Page
Loading...
