Alcatel-Lucent OmniAccess 5740 - Clocksource

clocksource
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
235
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CLOCKSOURCE
clocksource {internal|line}
DESCRIPTION
This command is entered in the Controller Configuration Mode to set clocksource
for E1 interface. The keyword "clocksource" is used to transmit clock signals. If a
controller is specified as a primary or backup clocksource by the network-clock-
select command, it must be set for clocksource line. Only one T1 or E1 controller
at a time can recover network clock and distribute it to the internal clock generator.
PARAMETERS
DEFAULT VALUE
The default value for clocksource is internal.
EXAMPLE
The following example configures the E1 clocksource to line:
ALU(config-controller E1)# clocksource line
Parameter Description
internal
The controller synchronizes itself to the
internal (system) clock.
line
The controller recovers external clock
from the line and provides the recovered
clock to the internal (system) clock
generator.