Alcatel-Lucent OmniAccess 5740 - Firewall Policy {In | out

firewall policy {in | out}
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
847
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
FIREWALL POLICY {IN | OUT}
firewall policy {in|out} <policy-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to attach a firewall policy (to which an intrusion sensor is attached) to an
interface in ‘in’ or ‘out’ direction.
PARAMETERS
Note: Firewall policy will take effect once it is attached to an interface.
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# firewall policy in P1
Parameter Description
in Firewall policy is applied to the ingress (incoming) traffic if
“in” keyword is used.
out Firewall policy is applied to the egress (outgoing) traffic if
“out” keyword is used.
policy name Name of the firewall policy.