Multicast Routing
Left running head:
Chapter name (automatic)
608
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP PIM BSR-CANDIDATE
ip pim bsr-candidate {BSRAdminZone prefix/mask <interface-
name>|<interface-name>} [<0-32>] [<0-255>]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the PIM router as BSR candidate. BSR uses specified interface
address.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# ip pim bsr-candidate GigabitEthernet3/0 1 10
Parameter Description
BSRAdminZone
prefix/mask
BSR Admin Zone can take all multicast addresses that is
greater than 224.0.0.0. For example, if the Admin Zone is
225.0.0.0/8, all the group addresses starting with 225 will
map to same Rendezvous Point (RP). This is used for
mapping multiple groups to same RP, when BSR is used for
RP election.
interface-name Name of the interface.
0-32 Indicates the hash-mask-length. This value is used to select
one RP.
0-255 Indicates the priority of the BSR router.
To Next Page
Loading...
Need help?
General
